[. . . ] Any usage other than described above is not permitted and can damage the productandleadtoassociatedriskssuchasshort-circuit, fire, electricshock, etc. Pleasereadthe operating instructions thoroughly and keep them for further reference. Observe all safety instructions and information within this operating manual. [. . . ] Green LED (REC) Battery compartment cover Temperature sensor socket The installation program starts automatically after inserting the CD. The installation program takes you semi-automatically through the program installation. During this, youhavetoacceptthelicenseagreementandhavetheoptiontodefineadifferentinstallation directory than the suggested one. Connect the datalogger to the computer when it is ready for operation. After a brief moment, the computer reports a new hardware and starts installing the USB driver. After the installation is complete, you can start the program "Type K Temperature Datalogger". Once you reprogram the data logger and save the settings, all previously saved data are deleted. - Connected = Data logger is ready for use - Not Connected = Data logger is not ready for use or is not connected. After you have successfully programmed the data logger, click on "Setup" in order to save the settings in the data logger. Scanning frequency in seconds / minutes / hours (1 second to 12 hours) Fahrenheit or Celsius Value triggering a warning when exceeded Value triggering a warning when under-run Flash frequency of the LED in seconds LEDdoesnotflash Manual start of the measuring operation by pressing the data logger button Measurement starts automatically after clicking "Setup" Time delay for automatic start of measurement (0 seconds to 5 hours) Reset settings Confirmsettingsforthedatalogger Cancel programming operation To utilise the full measurement range of the data logger, you will need a temperature sensor with a more extensive measurement range (available separately). â· Make sure only to use the temperature sensors specified to this effect for your measurements (in this case: K type). Before connecting lines, check plugs or sensor tips ("beads") for good condition and for flawless insulation (free of damage). â· Make sure that only the temperature sensors are exposed to the temperatures to be measured. Make sure to observe the safety provisions and the technical data as regards the service temperature. Never try to press mixed-up connectors (+ and -) forcefully into the bushes. This would destroy the bushes beyond repair, and they would have to be replaced. [. . . ] Use a clean, lint-free, antistatic and slightly damp cloth to clean the device. Do not use any abrasive or chemical agents or detergents containing solvents. In order to preserve, protect and improve the quality of environment, protect human health and utilise natural resources prudently and rationally, the user should return unserviceable product to relevant facilities in accordance with statutory regulations. [. . . ]